Accurate representation of the interplay between ecosystems and climate in Earth system models (ESMs) is important for understanding and predicting changes in carbon, water, and energy cycles. The traditional land components of ESMs often rely on the categorization of plant functional types (PFTs), a method that may overlook the ecological variations within plant groups. Using the CliMA Land model with surface hyperspectral data primarily sourced from Manuscript draft submitted to Ecosphere-SHIFT collection 2 AVIRIS-NG (Airborne Visible/Infrared Imaging Spectrometer-Next Generation) during the NASA's SHIFT (Surface Biology and Geology High-Frequency Time Series) campaign, we derive leaf biogeochemical traits, and compare a trait-based land modeling approach to the commonly used PFT one. Our findings reveal significant spatial and temporal variations in traits and other related optical and photosynthetic parameters, not only within the same PFT but also across different seasons. Validation against TROPOMI Solar-Induced Fluorescence (SIF) at 740nm shows that the trait-based approach enhanced model accuracy due to better representation of phenology and spatial heterogeneity. Our findings highlight the limitations of traditional PFTbased approaches in ESMs and underscore the importance of incorporating detailed, trait-based data for a more accurate and comprehensive understanding of ecosystem functions.

Since 2007, the National Academy for Sciences Engineering and Medicine (NASEM) has recommended priorities for Earth Science research and investment every ten years. The Decadal Survey balances the continuation of essential climate variable time series against unmet measurement needs and new Earth Observations made possible by technological breakthroughs. The next survey (2027-2028, DS28) must anticipate the observational needs of the 2030s-2040s, a world increasingly dominated by climate extremes and a rapidly changing Earth system. Here, we identify the critical Earth Observation needs for a hotter, more extreme world where expect challenges in maintaining a safe operating space.

As the planet approaches local and global exceedance of the 1.5o C stabilization target, damages from climate change, mostly due to extremes, are growing, far faster than projected. At the same time, assessment models have projected high costs of mitigation, but the cost of energy is dropping faster than projected. Climate policy has assumed that damage costs are manageable while decarbonization is expensive. Both these assumptions are wrong. Damage costs are rising rapidly and green energy costs are dropping quickly. potentially leading to a tipping point in human behavior: scientists need to explore options better aligned with this emerging reality.

Tropical lands play an important role in the global carbon cycle yet their contribution remains uncertain owing to sparse observations. Satellite observations of atmospheric carbon dioxide (CO2) have greatly increased spatial coverage over tropical regions, providing the potential for improved estimates of terrestrial fluxes. Despite this advancement, the spread among satellite-based and in-situ atmospheric CO2 flux inversions over northern tropical Africa (NTA), spanning 0-24◦N, remains large. Satellite-based estimates of an annual source of 0.8-1.45 PgC yr−1 challenge our understanding of tropical and global carbon cycling. Here, we compare posterior mole fractions from the suite of inversions participating in the Orbiting Carbon Observatory 2 (OCO-2) Version 10 Model Intercomparison Project (v10 MIP) with independent in-situ airborne observations made over the tropical Atlantic Ocean by the NASA Atmospheric Tomography (ATom) mission during four seasons. We develop emergent constraints on tropical African CO2 fluxes using flux-concentration relationships defined by the model suite. We find an annual flux of 0.14 ± 0.39 PgC yr−1 (mean and standard deviation) for NTA, 2016-2018. The satellite-based flux bias suggests a potential positive concentration bias in OCO-2 B10 and earlier version retrievals over land in NTA during the dry season. Nevertheless, the OCO-2 observations provide improved flux estimates relative to the in situ observing network at other times of year, indicating stronger uptake in NTA during the wet season than the in-situ inversion estimates.

Observations of Planet Earth from space are a critical resource for science and society. Satellite measurements represent very large investments and United States (US) agencies organize their effort to maximize the return on that investment. The US National Research Council conducts a survey of earth science and applications to prioritize observations for the coming decade. The most recent survey prioritized a visible to shortwave infrared imaging spectrometer and a multi-spectral thermal infrared imager to meet a range of needs. First, and perhaps, foremost, it will be the premier integrated observatory for observing the emerging impacts of climate change . It will characterize the diversity of plant life by resolving chemical and physiological signatures. It will address wildfire, observing pre-fire risk, fire behavior and post-fire recovery. It will inform responses to hazards and disasters guiding responses to a wide range of events, including oil spills, toxic minerals in minelands, harmful algal blooms, landslides and other geological hazards. The SBG team analyzed needed instrument characteristics (spatial, temporal and spectral resolution, measurement uncertainty) and assessed the cost, mass, power, volume, and risk of different architectures. The Research and Applications team examined available algorithms, calibration and validation and societal applications and used end-to-end modeling to assess uncertainty. The team also identified valuable opportunities for international collaboration to increase the frequency of revisit through data sharing, adding value for all partners. Analysis of the science, applications, architecture and partnerships led to a clear measurement strategy and a well-defined observing system architecture.

We assess the detectability of COVID-like emissions reductions in global atmospheric CO2 concentrations using a suite of large ensembles conducted with an Earth system model. We find a unique fingerprint of COVID in the simulated growth rate of CO2 sampled at the locations of surface measurement sites. Negative anomalies in growth rates persist from January 2020 through December 2021, reaching a maximum in February 2021. However, this fingerprint is not formally detectable unless we force the model with unrealistically large emissions reductions. Internal variability and carbon-concentration feedbacks obscure the detectability of short-term emission reductions in atmospheric CO2. COVID-driven changes in the simulated interhemispheric CO2 gradient and column-averaged dry air mole fractions of CO2 (total column or XCO2) are eclipsed by large internal variability. Carbon-concentration feedbacks begin to operate almost immediately after the emissions reduction; these feedbacks reduce the emissions-driven signal in the atmosphere carbon reservoir and further confound signal detection.

The retrival algorithms used for optical remote sensing satellite data to estimate Earth’s geophysical properties have specific requirements for spatial resolution, temporal revisit, spectral range and resolution, and instrument signal to noise ratio (SNR) performance to meet science objectives. Studies to estimate surface properties from hyperspectral data use a range of algorithms sensitive to various sources of spectroscopic uncertainty, which are in turn influenced by mission architecture choices. Retrieval algorithms vary across scientific fields and may be more or less sensitive to mission architecture choices that affect spectral, spatial, or temporal resolutions and spectrometer SNR. We used representative remote sensing algorithms across terrestrial and aquatic study domains to inform aspects of mission design that are most important for impacting accuracy in each scientific area. We simulated the propagation of uncertainties in the retrieval process including the effects of different instrument configuration choices. We found that retrieval accuracy and information content degrade consistently at >10 nm spectral resolution, >30 m spatial resolution, and >8 day revisit. In these studies, the noise reduction associated with lower spatial resolution improved accuracy vis à vis high spatial resolution measurements. The interplay between spatial resolution, temporal revisit and SNR can be quantitatively assessed for imaging spectroscopy missions and used to identify key components of algorithm performance and mission observing criteria.

Imaging spectroscopy is a remote-sensing technique that retrieves reflectances across visible to shortwave infrared wavelengths at high spectral resolution (<10 nm). Spectroscopic reflectance data provide novel information on the properties of the Earth’s terrestrial and aquatic surfaces. Until recently, imaging spectroscopy missions were limited spatially and temporally using airborne instruments, such as the Next Generation Airborne Visible InfraRed Imaging Spectrometer (AVIRIS-NG), providing the main source of observations. Here, we present a land-surface modeling framework to help support end-to-end traceability of emerging imaging spectroscopy spaceborne missions. The LPJ-wsl dynamic global vegetation model is coupled with the canopy radiative transfer model, PROSAIL, to generate global, gridded, daily visible to shortwave infrared (VSWIR) spectra. LPJ-wsl variables are cross-walked to meet required PROSAIL parameters, which include leaf structure, Chlorophyll a+b, brown pigment, equivalent water thickness, and dry matter content. Simulated spectra are compared to a boreal forest site, a temperate forest, managed grassland, and a tropical forest site using reflectance data from canopy imagers mounted on towers and from air and spaceborne platforms. We find that canopy nitrogen and leaf-area index are the most uncertain variables in translating LPJ-wsl to PROSAIL parameters but at first order, LPJ-PROSAIL successfully simulates surface reflectance dynamics. Future work will optimize functional relationships required for improving PROSAIL parameters and include the development of the LPJ-model to represent improvements in leaf water content and canopy nitrogen. The LPJ-PROSAIL model can support missions such as NASA’s Surface Biology and Geology (SBG) and higher-level modeled products.

High-resolution space-based spectral imaging of the Earth’s surface delivers critical information for monitoring changes in the Earth system as well as resource management and utilization. Orbiting spectrometers are built according to multiple design parameters, including ground sampling distance (GSD), spectral resolution, temporal resolution, and signal-to-noise. The different applications drive divergent instrument designs, so optimization for wide-reaching missions is complex. The Surface Biology and Geology component of NASA’s Earth System Observatory addresses science questions and meets applications needs across diverse fields, including terrestrial and aquatic ecosystems, natural disasters, and the cryosphere. The algorithms required to generate the geophysical variables from the observed spectral imagery each have their own inherent dependencies and sensitivities, and weighting these objectively is challenging. Here, we introduce intrinsic dimensionality (ID), a measure of information content, as an applications-agnostic, data-driven metric to quantify performance sensitivity to various design parameters. ID is computed through the analysis of the eigenvalues of the image covariance matrix, and can be thought of as the number of significant principal components. This metric is extremely powerful for quantifying the information content in high-dimensional data, such as spectrally resolved radiances and their changes over space and time. We find that the intrinsic dimensionality decreases for coarser GSD, decreased spectral resolution and range, less frequent acquisitions, and lower signal-to-noise levels. This decrease in information content has implications for all derived products. Intrinsic dimensionality is simple to compute, providing a single quantitative standard to evaluate combinations of design parameters, irrespective of higher-level algorithms, products, applications, or disciplines.