loading page

A prediction-oriented hazard assessment procedure based on the empirical falsification principle, application to the Atenquique debris flow, 1955, México
  • +4
  • Abani Patra,
  • Andrea Bevilacqua,
  • Marcus Bursik,
  • E. Bruce Pitman,
  • David Hyman,
  • Ricardo Saucedo,
  • José Luis Macìas
Abani Patra
University at Buffalo
Author Profile
Andrea Bevilacqua
Istituto Nazionale di Geofisica e Vulcanologia

Corresponding Author:bev87@hotmail.it

Author Profile
Marcus Bursik
University at Buffalo
Author Profile
E. Bruce Pitman
University at Buffalo
Author Profile
David Hyman
University at Buffalo
Author Profile
Ricardo Saucedo
Universidad Autònoma San Luis Potosì
Author Profile
José Luis Macìas
Universidad Nacional Autònoma de México
Author Profile

Abstract

In this study, we detail a new prediction-oriented procedure aimed at volcanic hazard assessment based on geophysical mass flow models with heterogeneous and poorly constrained output information. Our method is based on an itemized application of the empirical falsification principle over an arbitrarily wide envelope of possible input conditions. In particular, instead of fully calibrating input data on past observations, we create and explore input values under more general requirements of consistency, and then we separately use each piece of empirical data to remove those input values that are not compatible with it, hence defining partial solutions to the inversion problem. This has several advantages compared to a traditionally posed inverse problem: (i) the potentially non-empty intersection of the input spaces of partial solutions fully contains solutions to the inverse problem; (ii) the partial solutions can provide hazard estimates under weaker constraints potentially including extreme cases that are important for hazard analysis; (iii) if multiple models are applicable, specific performance scores against each piece of empirical information can be calculated. We apply our procedure to the case study of the Atenquique volcaniclastic debris flow, which occurred in the State of Jalisco (MX), 1955. We adopt and compare three depth averaged models currently implemented in the TITAN2D solver, available from vhub.org. The associated inverse problem is not well-posed if approached in a traditional way. However, we show that our procedure can extract valuable information for hazard assessment, allowing the exploration of the impact of model flows that are similar to those which occurred in the past, but differ in plausible ways.