To exploit the full material potential of short fibre reinforced PA6T/6I, specific component calculations including aniso- tropic material behaviour is necessary. For this, different failure criteria and fatigue models are used to describe the behaviour during a component service life. This paper deals with the determination and consideration of fibre orientations for failure criteria and fatigue calculations. Therefore, a novel method to determine fibre orientation (FO) distributions across injection moulded plates, is proposed. The developed method allows a forecast of FOs for different specimen extraction positions and angles on injection moulded plates by using only a few measured reference points. As a result, fatigue models can be calibrated with the strength values and the corresponding FO, calculated for fracture position. The performed tests show a non-negligible influence of failure positions, due to fibre orientation distributions along the specimens. So, the FO determination method delivers an improvement in strength values estimation.